Scratch built Acute Tool Sharpening System (Part 2)

This was left as a draft for a few days.  It should have preceded the UPDATE post by 2 days..

I have cut all the flat parts from 1/8" hot rolled on the sliding abrasive saw.
Wood Jigs or fixtures were used to cut the angles.
Wood jigs and drilling guides were used to drill the holes.

This morning I bent the bottom brackets.  They bent a bit too far.  A little time on the anvil will open them and a few blows while clamped in the vice will move them the other way.  Total adjustment.

Have top and bottom brackets cut drilled and bent for both new tables.  Now on to the links.  After that I will turn the round pressure disks and all the mild steel work will be finished but for the table top.  At that point I plan to rust blacken theses parts.