Friday, April 24, 2020

Atlas 10 inch H54 is home

Lathe looks to be good pictures in future posts.

Was wondering what these were for  Look to be cutters/mills with a non cutting guide or point.



Model H54
Bench Ready for Lathe
















Started cleanup.  Gave the table a coat of oil based poly.    Scrubbed the chip tray and hoisted the lathe up to the table.  The little crane obtained with this purchase did not work so I had to move the big engine hoist into the garage.









Used Engine Crane to Lift Lathe




Removed Carriage and Cleaned Ways




Finished installing the backgear.



Pulled everything but the headstock and cleaned the ways.  The machine looks to habe been repainted.   A few bolts don't match but its not a new machine.





No comments:

Post a Comment